Verify that the SYSTEM account is selected. If not,Ĭlick ‘Add’ and add the SYSTEM account. Now go to ‘Permissions’ tabĪnd select ‘Full Control’ under ‘Allow. This will set the permission levels for SYSTEM accountĪnd allows you to install it in any folder under the selected drive. DAZZLE DVC 100 SOFTWARE PINNACLE STUDIO 15 INSTALL
I do not have an encrypted folder or substitute drive.Sorry for the delay, got hungup with work. So to use Crossbar Thingy, make sure your Dazzle is hooked up and loaded into your program of choice (I'll use OBS as an example).ġ. Once the stream/capture has started, you should have no audio.Ģ. On the main CT window, highlight the "Dazzle DVC100 Crossbar" and click on "Open Selected Crossbar" (to the right).ģ. On the Dazzle crossbar, change the "Input Pin" dropdown then back again.
For example: change it from composite to s-vid then back to composite. This is to make the Apply button active on the window.Ĥ. Underneath the Input Pin you'll see a box that says "Link Related Streams." Enable that feature, then click on Apply, then OK.ĥ.
Back in OBS the audio should now start coming through. You'll notice the Dazzle video flashes as the device is restarted. Just remember that you'll have to run through these steps everytime you start a new preview/stream/capture session. Using AMCap instead (even if you get the demo version) is the preferred method since you only run the program and have it sit in the taskbar doing nothing to always have the audio enabled. Sorry to bump an old thread but I don't see where else I can find help on this problem. I'm using my Dazzle DVC100 to capture video gameplay from my consoles.
Has anyone any experience of using PD14 to capture video froma Dazzle DVC100 device ?
0 kommentar(er)
